Dacrylate appointed with The Royal Warrant

Dacrylate Paints Ltd.

Dacrylate Primers
Solvent Borne Acrylic Vinyl Primer

Solvent Borne Acrylic Vinyl Primer

Reference No.:47-1

High build acrylic vinyl, contains aluminium and rust inhibitor

High build primer for protection of steel and galvanised steel, including lighting columns, street furniture, metal fencing, plus general industrial plant. For use as a primer on areas of damaged Plastisol cladding prior to repainting.

Colours available: Aluminium
Appearance Of Dried Film: Matt
Volume Solids: 40% (may vary with colour)
Dry Film Thickness: Typical: 75 microns
Theoretical Coverage: 5.3m² per litre at 75 microns
Drying Time At 20°C:
Touch Dry: 1 hour
Film Dry: 3 hours
Overcoat: 3 hours
(will vary with temperature, air movements, etc.)
Packaging: 5 litre containers
Shelf Life: 12 monthsin unopened containers when stored under cover in good storage conditions.
Storage: Under cover with temperature range of 5°C to 32°C.
Surface Preparation: Mild steel, clean and free of millscale: Thoroughly degrease using Dacrylate Thinner R5.
Mild steel, corroded and/or millscale present: Abrasive blasting to ISO 8501-1 SA 2.5 is the preferred method.
Manual clean: Chip, scrape and power wire brush to remove all loose rust, millscale, etc. to ISO 8501-1, ST3. Degrease with Dacrylate Thinner R5.
Galvanising (new): Ensure surface is cleaned and dry. Pre-treat with Dacrylate Mordant Solutions (T Wash) Ref. 150-23.
Galvanising (weathered): Use stiff brush to remove any deposits of white zinc salts. Wash down with detergent water to remove road salts, etc., rinse and dry off. Degrease with Dacrylate Thinner R5 to remove any remaining oils, grease or other contaminants.
Application Conditions: Temperature: Minimum 5°C
Humidity: Less than 90% RH
Application: Brush: Apply using a 'full' wet brush. Avoid excessive 'brushing out' to maintain film build. A wet film thickness of 190 microns will give a dry film thickness of 75 microns.
Roller: As for brush application, taking care to apply specified wet film thickness.
Spray: SB Acrylic Vinyl Primer (Ref: 47-1) can be applied using conventional, airless and compliant spray methods. 5-10% of Dacrylate Thinner R5 may be required to give optimum spray characteristics.
N.B.: Certain products retain solvents for longer periods, which will affect plasticizers within the plastic packaging causing damage to the finish. It is therefore not recommended that finished painted products be wrapped in bubble wrap, plastic sleeves, etc., until coatings are fully cured as this can cause damage to the finish especially when stacked or stored in sunlight/elevated temperatures.
Damage can also occur from condensation caused by fluctuations in temperature consequently causing a 'greenhouse' effect within the packaging.
Clean-up: Dacrylate Thinner R5.
Health and Safety: For more information request relevant Material Safety Datasheet.

The above information is general information on the product but without warranty. Since conditions of service and application are beyond our control we cannot accept claims for loss, damage etc., based on this information. Dacrylate will not accept any claim for consequential or incidental damages.

BBA     BCF     ISO 9001     Royal Society of Chemisty     HEA HEMSA     IPL     Business in the Community     PaintCare     Made in Britain     SEDEX - Supplier Ethical Data Exchange