Dacrylate appointed with The Royal Warrant

Dacrylate Paints Ltd.

Dacrylate Primers
Vinaprime 41 HB Anti-Corrosion Primer

Vinaprime 41 HB Anti-Corrosion Primer

Reference No.:41-120

Vinyl/Zinc Phosphate

High build inhibitive primer for steel. Damp tolerant and fast drying.

Colours available: Buff (other colours to special order)
Appearance Of Dried Film: Low sheen
Volume Solids: 38%
Dry Film Thickness: Typical 50 microns / Range 35-75 microns
Theoretical Coverage: 7.6m² per litre at 50 microns
Drying Time At 20°C:
Touch Dry: 40 minutes
Film Dry: 2 hours
Overcoat: 2 hours
(will vary with temperature, air movements, etc.)
Packaging: 5 litre tins
Shelf Life: 2 years or longer in unopened containers when stored under cover in good storage conditions.
Storage: Under cover with temperature range of 5°C to 32°C.
Surface Preparation: Steel: Preferred method is abrasive blast to ISO 8501-1 SA 2.5.
Manual cleaning: Chip, scrape and power wirebrush to remove all loose millscale, rust and other surface contaminants. Degrease with Dacrylate Thinner R5.
Application: Airless or conventional spray, brush or roller.
Note: Care should be taken with application by roller to ensure the correct film build has been applied. A wet film thickness of 135 microns must obtained to give a dft of 50 microns.
Brush application: Apply using full wet brush. Do not attempt to 'brush out' or 'lay off'.
Note: Brush application is the preferred methods for use on damp surfaces.
N.B.: Certain products retain solvents for longer periods, which will affect plasticizers within the plastic packaging causing damage to the finish. It is therefore not recommended that finished painted products be wrapped in bubble wrap, plastic sleeves, etc., unitl coatings are fully cured as this can cause damage to the finish especially when stacked or stored in sunlight/elevated temperatures. Damage can also occur from condensation caused by fluctuations in temperature consequently causing a 'greenhouse' effect within the packaging.
Clean-up: Dacrylate Thinner R5.
Health and Safety: For more information request relevant Material Safety Datasheet.

The above information is general information on the product but without warranty. Since conditions of service and application are beyond our control we cannot accept claims for loss, damage etc., based on this information. Dacrylate will not accept any claim for consequential or incidental damages.

BBA     BCF     ISO 9001     Royal Society of Chemisty     HEA HEMSA     IPL     Business in the Community     PaintCare     Made in Britain     SEDEX - Supplier Ethical Data Exchange