Dacrylate appointed with The Royal Warrant

Dacrylate Paints Ltd.

Dacrylate Primers
Rapidac Metal Primers

Rapidac Metal Primers

Reference No.: 13-Line

(Single Pack General Purpose Fast Drying Primer)

A modified alkyd/zinc phosphate fast drying primers for general purpose use on steel.

Colours available: Red Oxide , Avion Blue, Grey, Grey/Green, White, Buff
Appearance Of Dried Film: Low sheen
Volume Solids: 40% (may vary with colour)
Dry Film Thickness: Typical 40 microns / Range 30-50 microns
Theoretical Coverage: 10m² per litre at 40 microns
Drying Time At 20°C:
Touch Dry: 20 minutes
Film Dry: 1 hour
Overcoat: See Note
(will vary with temperature, air movements, etc.)
V.O.C.: 510grms/litre (may vary with colour)
Packaging: 5 and 20 litre containers
Shelf Life: 2 years or longer in unopened containers when stored under cover in good storage conditions.
Storage: Under cover with temperature range of 5°C to 32°C.
Surface Preparation: Preferred method is abrasive blast to BS:4232 Second Quality.
Manual Clean : Chip, scrape and wire brush to remove all loose millscale, rust, etc. Degrease with Dacrylate Thinner R5.
Clean, mild steel (free of rust and millscale)
Decrease with Dacrylate Thinner R5.
Application: Maybe applied by conventional or airless spray. Up to 10% Dacrylate Thinner R5 maybe added to obtin optimum spray characteristics.
Apply to an approximate wet film thickness of 100 microns to achieve 40 microns dry film thickness.
Small areas and narrow sections can be brush applied. Apply with a full wet brush, do not attempt to 'brush out' or 'lay off'.
Overcoating: Maybe overcoated after 45 minutes or as soon as film-dry with all white spirit based finishing coats (eg. Dacrylate Vehicle and Machinery Enamels, QD2, DacSheild, etc.)
Fast-drying finishing coats based on stronger solvents (eg. Dacrylate QD3, QD1, etc.) should be overcoated when primer is firm-dry but within 2 hours, or allow primer to dry overnight.
Note: Overcoating and drying times will depend on ambient temperatures and especially ventilation, air movement, etc.
Clean-up: Dacrylate Thinner R5.
Health and Safety: For more information request relevant Material Safety Datasheet.

The above information is general information on the product but without warranty. Since conditions of service and application are beyond our control we cannot accept claims for loss, damage etc., based on this information. Dacrylate will not accept any claim for consequential or incidental damages.

BBA     BCF     ISO 9001     Royal Society of Chemisty     HEA HEMSA     IPL     Business in the Community     PaintCare     Made in Britain     SEDEX - Supplier Ethical Data Exchange