Dacrylate Paints Ltd.

High Performance Coating Solutions

Dacrylate Highways Agency Coatings
Epidac 2 HB Epoxy Undercoat

Epidac 2 HB Epoxy Undercoat - Item 116

Reference No.: 90-269

A high build epoxy undercoat compliant to Environmental Protection Act (1990) Clause 20(d) Guidance Notes PG6/23 (97). Typically used as a high-build epoxy undercoat for up-grading existing chlorinated rubber, vinyl, acrylated rubber, oleoresinous, alkyds, silicone alkyds and similar applications. Epidac 2 HB Epoxy Undercoat is tolerant of surface moisture.

Colours available: Light Grey
Appearance Of Dried Film: Gloss
Volume Solids: 75% + 2%
Dry Film Thickness: Typical 100 microns / Range 75-150 microns
Theoretical Coverage: 7.5m² per litre at 100 microns dry film thickness
Drying Time At 20°C: Touch Dry: 3 hours
Film Dry: 8 hours
Overcoat: 8 hours with polyurethane coatings
(will vary with temperature, air movements, etc.)
Drying Time at Lower Temperatures:
  10°C 5°C
Touch Dry
Firm Dry
Overcoat
6 hours
12 hours
12 hours
16 hours
24 hours
24 hours
V.O.C.: 206 grams/litre
Packaging: 5 litre composite packs
Shelf Life: 2 years in unopened containers when stored under cover in good storage conditions.
Storage: Under cover with temperature range of 5°C to 32°C.
Surface Preparation: Abrade any aged gloss finishes and dDegrease with Dacrylate Thinner R5.
Application Conditions: Temperature above 4°C.
Humidity less than 90% RH.
Epidac 2 HB Epoxy Undercoat can be applied direct to damp/wet surfaces. Brush application is the preferred application method to ensure displacement of water from the substrate.
Application: Apply by brush or airless/air-assisted airless spray.
Airless spray: Tip pressure 2500psi (170 bar). Tip size 13-15 Thou (0.33-0.38mm).
Apply to wet film thickness of approximately 135 microns to achieve a dry film thickness of 100 microns.
Overcoating: When overcoating non-convertible paints, eg., chlorinated rubber or vinyl or similar, the dry film thickness should be not more than 75 microns. Apply with full wet brush, do not 'brush out' or 'lay off' to avoid solvent attack or solvent entrapment.
Pot Life (at 20°C): 4 hours
Mixing ratio by volume: 4: 1
Clean-up: Dacrylate Thinner R5.
Health and Safety: For more information request relevant Material Safety Datasheet.

The above information is general information on the product but without warranty. Since conditions of service and application are beyond our control we cannot accept claims for loss, damage etc., based on this information. Dacrylate will not accept any claim for consequential or incidental damages.

BBA     BCF     ISO 9001     Royal Society of Chemisty     HEA HEMSA     IPL     Business in the Community     PaintCare     Made in Britain     SEDEX - Supplier Ethical Data Exchange